Ever seen a 12-foot zipper

Longarm machines come in standard sizes, usually measure by the table size. There are 8 ft tables which is pretty small and there are 10, 12 and 14 foot tables. The big ones can easily accomodate a kingsize bedspread. All longarm quilting machines use an industrial motor in a large-throated machine head. The throat is the opening in the middle where the stitching takes place. The average home sewing machine has a throat that is 5 inches by 7 inches. The throat on a longarm is usually 10 inches high by 24 - 26 inches wide. It is much bigger than doestic sewing machine(DSM). Longarm machines also use rollers to mount the quilt on the machine for quilting. They have a set (usually four) of rollers covered in canvas leaders that run the length of the quilt table. So the rollers are 8 - 14 feet long. Mounting a quilt on a longarm can be time-consuming and, if you use pins, somewhat painful...pins hurt when they stick you.

Some wizard came up with the idea to use zippers on longarm machines so that quilts could easily be zipped on and off. Zippers.... you will love them once you get the procedure down. First you have to install the zippers.

You get 3 complete zippers in a machine set. They come with excellent instructions though the zippers are clearly labelled.

You sew 3 of the half zippers onto your longarm canvas leaders. My husband helped with this. He just steadied the zipper against the canvas as I slowly sewed it with the longarm.

The other 3 zipper halves are really not interchangable. They are marked something like "Backing Bottom Left", "Backing Top Left" and "Quilt Top Takeup". You must pay attention to ensure that you do not mount the backing with the right side facing up....in other words, the backing pretty side faces the batting. Bad mistake.

I baste (or you can pin) the top and bottom of the backing on separate zipper halves using my domestic sewing machine (DSM). If you are not floating the quilt top, then the bottom of the quilt top gets basted/pinned to the zipper marked "quilt top.

Snowman and Mittens

This is the sixth quilt that I have done for Joanne. It is all flannel, front and back. The front looks like a panel, although it is yardage. There are squares of snowmen and snow-women printed on the fabric as well as the sashing. It is very cute. So this was kind of like a Just Can't Cut It quilt.

Joanne used three borders, a 1-inch burgundy, a blue with holly leaves and the coordinating mitten and caps that go with the snowman print. I echoed the snow-people in the blocks and did some movement quilting in the blocks to get me over to the sashing which is wavy lines with pebbles at the intersections of the blocks. Here is the detail of the snowman block, sashing and borders. I did simple wavy loops in the inner border after I SIDd down all the borders. I quilted holly and berries in the blue border. The outside border, I used loops and outlined some of the mittens and caps.


I used Superior's So Fine #435 It's a Boy thread on the top. The bobbin is Superior's Bottom Line #610 Light Blue thread.

Here is another close-up. In this one you can see the perfectly spaced snowman and mittens border that I got from www.perfectborders.com in less than 5 minutes of online time. I love perfectborders.com.


The back was pieced, the sides were the mitten/cap print in blue and the center was the same print but in the blue color way.